Installation Requirements:
Door thickness: 35-50 mm
Backset: 60 or 70 mm
Lockstile: 95 mm
Screen Door Clearance: 700 mm
Required Tools
Prepare the door and check dimensions
Measure and confirm the following:
Measure and confirm the following:
a. The hole in the door face is 1-1/2″ or 2-1/8″ (38mm or 54mm).
b. The hole in the door edge is 1″ (25mm).
c. The backset is 2-3/8″ or 2-3/4″ (60mm or 70mm).
d. The door thickness is 1-3/8″ to 2″ (35mm to 50mm).
Make sure the hole in the door frame is drilled a minimum of 1″ (25mm) deep, to leave enough space for the deadbolt to extend into the door frame when the door is locked.
Attention: Make sure the door frame is aligned with the door and there are no obstructions in the door frame.
Determine the backset and adjust the latch
Hold the latch in front of the door hole, with the latch face flush against the door edge. Is the slotted hole centered in the door hole?
YES - No adjustment is required. Proceed to the next step.
NO - Slotted hole is NOT centered.
Rotate and pull the latch to extend it.
Install the latch bolt
Use a screwdriver to confirm that the deadbolt locks and unlocks smoothly.
If it cannot rotate smoothly because the door hole is too small, remove the latch bolt and chisel out a small channel at the top of the hole to give the cam of the latch bolt room to rotate.
Install the strike on the door frame. Make sure the hole in the door frame is drilled a minimum of 1″(25mm) deep. Install exterior assembly
Attention: Before installation, make sure the latch is fully retracted (in the unlocked position).
Do not insert the key when you are installing.
Install the Exterior Assembly
With the latch bolt fully retracted (in the unlocked position), route the cable below it and insert the taipliece through the slot in the latch bolt.
⚠️ Attention: The Upper Screw and Screw post on the top is OPTIONAL. It is used for additional security, or when the door is weak or warped.
Move the installation buckles on both sides of the interior assembly upwards to remove the mounting plate from the interior base.
Secure the mounting plate with the Mounting Plate Screws. Do not overtighten screws.
⚠️ Attention:
Route the cable through the hole in the Mounting Plate.
The Upper Screw is OPTIONAL
Before installing the upper screw, fasten the screw post into the hole of the exterior assembly.
Install the interior assembly
Push the battery cover up in the direction as illustrated.
Attention: Do not load batteries before finishing the lock installation.
Insert the cable connector of the exterior assembly into the socket on the interior assembly. Push the connector in firmly until it is completely attached.
Keep the thumb turn in the vertical position, toggle the installation buckle upwards, and install the Interior Assembly.
Attach the Interior Assembly to the Mounting Plate, toggle the installation buckle downwards, and fasten using the Interior Assembly Screws.
⚠️ Attention: Ensure the cable is not pinched, or the lock will not function properly.
Install the AA batteries.
Press and hold the Reset Button for at least 5 seconds until you hear a beep. This activates the lock-handing process and must be completed before setting up the lock.
