Skip to main content

DDL303-VP-5HWS Programming & Factory Reset

Updated over 2 weeks ago

Adding an Admin User

  1. Press and hold the [#] key.

  2. Verify using any master access method:

    • Master fingerprint

    • Master PIN code

    • Master key tag

  3. Press [1] to access Master Mode.

  4. Press [1] again to add an admin.

    **After performing the above steps, proceed with either of the below options depending on the access that you'd like to register**

To add an admin PIN Code

  1. Enter the master PIN code, then press [#] to confirm.

  2. Re-enter the same PIN code and press [#] again.

  3. A voice prompt will confirm that the PIN code has been added successfully.

Add an admin Fingerprint

  1. Place your finger on the fingerprint sensor.

  2. Follow the voice prompts to lift and re-place your finger.

  3. Enrollment is complete when the voice prompt confirms success.

Add an admin Key Tag

  1. Follow the voice prompts to present the key tag.

  2. Enrollment is complete when the voice prompt confirms success.

⚠️Important Notes

  1. User codes 1 to 9 are reserved for master users.
    Master users can be verified using a fingerprint, PIN code, or key tag.

  2. The PIN code length is 8 digits.

How to Delete an admin:

  1. Press and hold the [#] key.

  2. Verify using any master access method:

    1. Master fingerprint

    2. Master PIN code

    3. Master key tag

  3. Press [1] to access Master Settings, then press [2] to delete a master user.

  4. Select the master PIN code, fingerprint, or key tag to delete.

  5. Press [#] to confirm.

  6. A voice prompt will confirm that the deletion was successful.

How to Add a User PIN:

  1. Press and hold the [#] key.

  2. Verify using any master access method:

    1. Master fingerprint

    2. Master PIN code

    3. Master key tag

  3. Press [2] to enter User Settings, then press [1] to add a user.

  4. Enter the new user PIN code and press [#] to confirm.

  5. Re-enter the PIN code and press [#] again.

  6. A voice prompt confirms successful addition.

How to Add a User Fingerprint:

  1. Press and hold the [#] key.

  2. Verify using any master access method:

    1. Master fingerprint

    2. Master PIN code

    3. Master key tag

  3. Press [2] to enter User Settings, then press [1] to add a user.

  4. Place the finger on the fingerprint sensor.

  5. Follow the voice prompts to lift and re-place the finger until enrollment is confirmed.

How to Add a User Key Tag

  1. Press and hold the [#] key.

  2. Verify using any master access method:

    1. Master fingerprint

    2. Master PIN code

    3. Master key tag

  3. Press [2] to enter User Settings, then press [1] to add a user.

  4. Follow the voice prompts to enroll the key tag until confirmed.

How to Delete a User

  1. Press and hold the [#] key.

  2. Verify using any master access method:

    1. Master fingerprint

    2. Master PIN code

    3. Master key tag

  3. Press [2] to access User Settings, then press [2] to enter User Deletion.

  4. Delete a Specific User

    • Press [1] and enter the user’s PIN code, fingerprint, or key tag.

    • Press [#] to confirm.

    • A voice prompt confirms successful deletion.

  5. Delete All Users

    • Press [2], then [#] to confirm.

    • A voice prompt confirms that all users have been deleted.

How to Perform a Factory Reset

Did this answer your question?